Circles not round
Posted by Tryptamine
|
Circles not round December 20, 2022 04:47PM |
I have a coreXY printer (Hypercube Evolution)
Today I found out, that shapes prints are distorted:
A circle is not a circle, but wider along the Y-axis than along the X-axis, by half a millimetre.
Where could this problem come from?
The belts are tensioned. The angles are 90deg. Both motors for XY movement are identical and have the same steps/mm set in config.
I am running out of ideas.
Today I found out, that shapes prints are distorted:
A circle is not a circle, but wider along the Y-axis than along the X-axis, by half a millimetre.
Where could this problem come from?
The belts are tensioned. The angles are 90deg. Both motors for XY movement are identical and have the same steps/mm set in config.
I am running out of ideas.
Sorry, only registered users may post in this forum.