I'm building a darwin and my arduino had stoped working so i switched to sanguino, and since then my axis wont move.
I'm using arduino 0018 software with the sanguino extension and gen2 firmware.
I've connected the pins as it said in this Gcode interperter:
Gcode, and ofcourse this is the one i'm using.
with the use of a serial monitor i confirmed that the communication is established and the correct movment orders are sent.
one more thing, once the order is sent the leds on the stepper board turn off, even though the potentiometer gives them enough power.
and still i see no movment, can anyone help?
Edited 1 time(s). Last edit at 07/27/2010 06:15AM by asaf.
