Welcome! Log In Create A New Profile

Building a RepRapPro Huxley - Heatbed question

Posted by SNGLinks

SNGLinks

Building a RepRapPro Huxley - Heatbed question
January 12, 2013 06:40PM

Registered: 11 years ago
Posts: 6

Building a RepRapPro Huxley. Got to the stage of making the heatbed.
Do I put washers between the heatshield and the PCB?
They are marked on the heatshield but not mentioned in the instructions.

What happens if I don't use heatsink compound on this?

Thanks
Ashley

Reply Quote

herisuprapto

Re: Building a RepRapPro Huxley - Heatbed question
January 14, 2013 07:48AM

Registered: 11 years ago
Posts: 90

Hi Ashley,

I do not use it, do not know what I'm doing is right or not but so far everything is going well.

I put it on the bottom, like this:
[www.reprap.org]

But there is someone who had a much longer about this can tell us.

Regards,
Heri

Reply Quote

SNGLinks

Re: Building a RepRapPro Huxley - Heatbed question
January 15, 2013 07:19PM

Registered: 11 years ago
Posts: 6

Had an answer from RepRapPro Ltd - the washers aren't required between the PCB and the heatshield.

Ashley

Reply Quote

herisuprapto

Re: Building a RepRapPro Huxley - Heatbed question
January 15, 2013 10:30PM

Registered: 11 years ago
Posts: 90

Now, it's all taken care of, thank you.

Regards,
Heri

Reply Quote

Newer Topic Older Topic

Print View RSS

Sorry, only registered users may post in this forum.

Click here to login