Hello, First off wanna say thanks for the information in these forums they have been very useful.
I level my bed.
I set the z axis opto level looks great until print starts.
The z axis moves up after the print starts.. i can pause print hit z home and it will go down to were needs to be, until i hit resume then it moves back up half a mm and resumes the print.
I am constantly adjusting my z opto switch so that it crashed into glass when homed.
Then moves up to were it needs to be when job starts.
I found a link to a command that let me set the zero on the z axis in pronterface. cant find same post again to try and reverse what i did.
using slic3r 0.9.10 and newest version of pronterface.
thanks