Welcome! Log In Create A New Profile

Auto Bed Level - Don't retract probe between measurements

Posted by Egar

Forum List Message List New Topic

Egar

Auto Bed Level - Don't retract probe between measurements
April 15, 2014 11:13AM

Registered: 10 years ago
Posts: 16

Hi there,

Is there a way to tell Marlin not to retract the Z-Probe between each measurement during G29?

Thanks!

Reply Quote

eci22

Re: Auto Bed Level - Don't retract probe between measurements
April 21, 2014 11:30AM

Registered: 10 years ago
Posts: 53

Hi,

Set your retract angle to the same as your extend angle in marlin, after you have performed leveling send a M280 command to retract the servo manually

e.g.
G29
M280 P0 Sx ; where x is the desired angle of retraction.

You could put this into a macro to make it automated.