Welcome! Log In Create A New Profile

Marlin

Posted by andybratton

andybratton

Marlin
September 13, 2014 06:32PM

Registered: 9 years ago
Posts: 6

Anybody got any advice for switching over from Sprinter to Marlin? I'm running a Prusa i2 with a Mega and RAMPS.

Reply Quote

Evil Monkey

Re: Marlin
September 14, 2014 12:08AM

Registered: 11 years ago
Posts: 177

Should load right up, it's very similar. Go to configure.h and adjust your settings to suit your machine and it's good to to go.

[scara3dprinter.wordpress.com]

Reply Quote

Newer Topic Older Topic

Print View RSS

Sorry, only registered users may post in this forum.