Hey guys I made autobed leveling with servo
First try uploading marlin was fine then I needed to calibrate z and y axis cause cube was a bit off.
When I tryed again to correct autobed leveling every time I put values for probing it tells me some floating error and even if I try again on different spot I still get floating error , on x probe or y probe...
What does it mean why this is happening...
Solution : Decimals on X or Y arent friends with marlin, only Z is, so when I put whole number on X and Y it was ok.
Edited 1 time(s). Last edit at 02/29/2016 03:46AM by Beer4Brew.