How to run a 100K thermistor in megatronics V2

I realized that unlike Arduino, Megatronics V2 has its own pin for thermistor. This confuses me. How to wire the thermistor then? Do I still need to link a 100K thermistor to the analog pin like arduino, or I just directly link the thermistor onto the thermistor pin and does not need a 100K resistor?
Also, the coding in megatronics of thermistor is different from Arduino. The test code of megatroincs has a temperature table, what is that anyway? thx

According to the image


The 6 pins to the right of the stepper drivers are fo T0 T1 T2 thermistors, the board has its own pullup resistors .

Edited 1 time(s). Last edit at 10/28/2018 05:16AM by obewan.

Thank you very much