Welcome! Log In Create A New Profile

ABS temp

prairiewolf407

ABS temp
February 21, 2013 03:30AM

Registered: 14 years ago
Posts: 38

what temp do you guys run your hot end at when using abs i have been ruining at 230 but it seem to be melting my parts and this is with a fan so just hoping somebody else might run at a different tem

Reply Quote

nophead

Re: ABS temp
February 21, 2013 06:29AM

Admin
Registered: 19 years ago
Posts: 7,883

250C if I want them strong.

[www.hydraraptor.blogspot.com]

Reply Quote

Komb'

Re: ABS temp
February 21, 2013 09:43AM

Registered: 14 years ago
Posts: 198

... melting your parts? Pictures?

Are you sure it's ABS?

Depending on the supplier, I run ABS between 235-250c and prints cone out nice.

However those temps would be way to high for PLA. 185-190c I use for PLA at >220 I'm sure it would be a melted mess.

Komb'
Glankonian Protoforms

Reply Quote

prairiewolf407

Re: ABS temp
February 25, 2013 01:41AM

Registered: 14 years ago
Posts: 38

it is abs from bilby cnc and
i don't have any good photos because i just thought it in with my abs juice once it screws up

Reply Quote

jbernardis

Re: ABS temp
February 25, 2013 08:31AM

Registered: 13 years ago
Posts: 1,320

It melts the thing you're printing, or it melts your existing x carriage/extruder?

I once was using a PLA x carriage that was melting when I was printing ABS. I just struggled through getting an x carriage printed out of ABS, and once I had one that was serviceable, I printed two more so that I had some spares.

Reply Quote

prairiewolf407

Re: ABS temp
February 26, 2013 04:01AM

Registered: 14 years ago
Posts: 38

it melts the thing i'm printing well it makes it look like it melting and the layers lift up some times for no reason