Welcome! Log In Create A New Profile

Advanced

Please assist me with my 6 wire NEMA17 motors.

Posted by LordTovar 
Please assist me with my 6 wire NEMA17 motors.
February 23, 2013 10:58PM
Hello,

I am building a Mendel Prusa Iteration 2. I have 5 NEMA 17 motors. They are 6 wire. I am hooking them up to Ramps 1.4 which have a 4 cable design. My question is which wires do I solder and which two do I leave off? I broke them up to three groups of two as you can see in one of the two photos. I feel like the 2 middle ones I should as I tried touching each pair together and I felt the resistance on the two pairs on the ends. The middle pair did nothing. Please guide me in the right direction. Im looking forward to printing. Here is the model information about the actual motors themselves. I bought them from Ebay and this is the spec sheet that they included.

Lot of 5 Stepper Motors. 17PM-K103-19V.

Current 1.2A

Voltage 12-36VDC.

Comes with 6-Lead Wire and Anti-Vibration mount. Please note wire lenght ia about 2" long

Frame Size Nema 17 / 1.8 Degree Step

Easy Wiring. A+ | Common| A- | B+ | Common | B- |

Dimensions 42mm x42mm x 42mm

2 X Ball Bearings

Shaft 5mm

Shaft lenght 20.00mm / 0.787"

More Specs:

[cncsuperstore.com]



I am new to the whole printing thing so Im just trying to make sure that I get it correct.
Thanks !

Edited 2 time(s). Last edit at 02/23/2013 11:07PM by LordTovar.
Attachments:
open | download - photo.JPG (471.5 KB)
open | download - MotorName.JPG (379 KB)
Re: Please assist me with my 6 wire NEMA17 motors.
February 24, 2013 02:08AM
Have a look at this..

[www.youtube.com]
Re: Please assist me with my 6 wire NEMA17 motors.
February 24, 2013 05:47AM
It's Figure A here [www.theprojectasylum.com]
Sorry, only registered users may post in this forum.

Click here to login