help with mounting my hot end to my extruder.

Hello everyone. Just got back into it again. I am going to try to make this one better than the last one. Which I sold cause I got frustrated .
So heres what I have so far. The extruder Greg's hinged accessible. The hot end is a ebay buy from the Netherlands. This was noted on ebay where I bought my plastic parts for the Prusa. "[/i]-ABS parts for Greg's Accessible (Wade's) Extruder, modified with mounting plate for groove mount style hotends(J-Nozzel, MakerGear) and filament guide[/i]" So with all that being said. Here are some pictures for you. Maybe someone will explain to me how to install the hot end to the extruder to the x carrage and so on.

WOW. Thought by now someone would have some advise. Where are all the veterans
Steve

I don't know what the problem is, but I would put the extruder (the motor and the gear box IMG_20130301_161303.jpg) on top of the carriage (IMG_20130301_161226.jpg), then put the hot end PTFE with the wooden part (seen in photo IMG_20130301_161316.jpg) beneath the carriage, and put two bolts going through the 2 big holes from top to bottom. That would make them stay together with the carriage. Does that make any sense?

Check page 85 and see if it helps.
[dl.dropbox.com]
Looks like from the pictures your hot end will fit into the extruder and bolts will go thru the carriage, extruder and hot end wood plate.