Having issues with print. (Video link)

youtube.com/#/watch?v=DpZM0nodakE


I'm having issues with my prints. I set the mm per second on the EEPROM settings in Repetier-host for my MBP. I was tring to print out a coin and this is what it does. I fixed the Z endstop so it's two pieces of paper distance between nozzle and bed. Any ideas as to why this is doing this? I'm printing ABS at 220c and bed is at 110c .35 mm nozzle and 3mm

Lower your endstops. I zero my Z axis right to the build surface at temperature. A standard piece of printer paper is 0.1mm.

That's putting your first layer at .2mm + 1/2 your layer height(depending on slicer and settings), resulting in not getting first layer adhesion.

What layer height are you trying to print at?