Hi..
I have a ramps 1.4 from Gadgets3D, with G3D Driver.
Today I tried test the steppers, and found that the Y stepper only run in -Y direction.
I used the pronterface software and marlin
I tried sprinter too, with same results.
I checked the endswitches, swapped the pololu drivers, and same result..
The same motor runs well in others positions.
The stepper motor is a 42BYGH4803 -04 with yellow, green, red, blue wire colors
my connectios are: Red - 1A; Green - 1B; Yellow - 2B; Blue - 2A
I appreciate if someone could help me.
thank you in advance
ant