Welcome!
Log In
Create A New Profile
Home
>
Reprappers
> Topic
Advanced
Hotend Jammed! how to clean that
Posted by
gm_chandru
Forum List
Message List
New Topic
gm_chandru
Hotend Jammed! how to clean that
December 11, 2013 02:02PM
Registered: 11 years ago
Posts: 12
Hello,
I have built my Prusa I3 and today i was doing some Calibration Cube print testing.
after some time hotend stopped extruding i have increased the temperature and did all .trial and error.
But No result. what is the process to clean HotEnd when it jammed?
Regards,
Chandru
Reply
Quote
woodencase01
Re: Hotend Jammed! how to clean that
December 11, 2013 10:55PM
Registered: 12 years ago
Posts: 112
Usually, I just heat the hot end, untighten the screw from the extruder, slowly pull out the filament, cut the larger diameter portion, put everything back as it was and start the new print. Done in less than a minute.
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login