Tricolour Mendel

Hi guys,,
am working on reprappro mendel, I tried so many times to install the Melzi Processor and it won't work

am wondering if I can use the Processor of Mendel Tricolour..?

Here is a pic of the processor of single colour ( the one with the red jumper ) and tricolour ( the other one )

I hope to get your interaction as soon as possible, because am stuck in here. thanks in advanced.

Both boards are exactly the same for the tricolour with multiple extrusion heads one board is run as a slave controller.

Ben

Where did you get them from? where they not labelled?

Ben

from reprappro,
they're labelled but after I tried the single colour board and it is not working I said maybe it's the same as tricolour's.

Could you be more specific? Describe the steps you have taken to get the board working and what the result was.

The single colour board is the main board and should be used for the first hot end and extruder, the other board is the slave board for the additional hot ends and extruders.

Ben