Welcome! Log In Create A New Profile


Tricolour Mendel

Posted by Omar991 
Tricolour Mendel
April 05, 2014 04:46PM
Hi guys,,
am working on reprappro mendel, I tried so many times to install the Melzi Processor and it won't work sad smiley

am wondering if I can use the Processor of Mendel Tricolour..?

Here is a pic of the processor of single colour ( the one with the red jumper ) and tricolour ( the other one )

I hope to get your interaction as soon as possible, because am stuck in here. thanks in advanced.
open | download - image.jpeg (585.7 KB)
Re: Tricolour Mendel
April 06, 2014 04:57PM
Both boards are exactly the same for the tricolour with multiple extrusion heads one board is run as a slave controller.

Re: Tricolour Mendel
April 06, 2014 05:12PM
Where did you get them from? where they not labelled?

Re: Tricolour Mendel
April 07, 2014 03:26AM
from reprappro,
they're labelled but after I tried the single colour board and it is not working I said maybe it's the same as tricolour's.
Re: Tricolour Mendel
April 07, 2014 06:48PM
Could you be more specific? Describe the steps you have taken to get the board working and what the result was.
Re: Tricolour Mendel
April 10, 2014 02:59PM
The single colour board is the main board and should be used for the first hot end and extruder, the other board is the slave board for the additional hot ends and extruders.

Sorry, only registered users may post in this forum.

Click here to login