Hello, I'm new and I have just finished mounting the German X400 with dual extruders, took me sometime but everything seems ok right now.
I've installed the drivers, software and firmware. At first all the motors moved fine but had to push the turn motor off button after because otherwise they start vibrating, moving incorrectly and making a lot of noise. But now the motors just stopped moving . . .
I turned off and on again, disconnected everything and reinstalling drivers, etc.
Everything else seems to work but when I send the order to the motors: the order is sent correctly, got the acknowledge message, there's no error message at all but the motors won't move at all . . . . .
If anyone could help me or at least point me how could I solve this or the reason why it happens ? ? ?
Thank you very much in advance for your time and help.