Hi folks,
I recently bought some new pla from a different supplier.
first with the new black filament i had no issues,
now i tried the silver and it wont extrude it, i changed back to my original suplier filling and that goes fine!.
Then i tried the black again, and even black does not print now. :s
i tried many different temps but nothing works.
normally when my hot end is heated and idle, there come lines of plastic out of my hot end wich curl up, with this new filament there seems to just hang a drop of plastic to the hot end and it does not print.
Can anyone help? and yes it the correct 3mm filament i need
thx