I was supposed to print for the first time this week, but after some final tweaks the ramps board and Mega 2560(not Arduino original) burned out. The power is getting through the 5A fuse(the one near the two fuses) but not through diode d1 which shows 0V. The Mega 2560 won't connect to my computer, it was found as an unkown device both on Linux and Windows. Also the leds shine brighter with the mega attached to my computer then the ramps board power supply. Is their any chance salvaging the equipment? If not what are your opinions on gen 7 electronics?
-Damian
