Welcome! Log In Create A New Profile


steppers grunting

Posted by 65c10restomod 
steppers grunting
July 13, 2014 05:30PM
Ive got a newly built prusa mendel with ramps 1.4 and all I got hooked up is one stepper just to see if I can get it to work but all it does is grunt when I try to move it with the software do the end stops need hooked up to get it to move.My software is repitier with repitier firmware ive tried pronterface and sprinter and it does the same thing
Re: steppers grunting
July 14, 2014 12:28AM
I got it working.not sure what i did but its working now
Re: steppers grunting
July 14, 2014 04:35PM
Did you adjust the voltage on the motor drivers? If it just started to work, or possibly started working after resetting the RAMPs board, I had a similar issue because the motor wires I terminated myself sucked.

Glad you got it working.
Sorry, only registered users may post in this forum.

Click here to login