Hello everyone, this is a duplicated post from my topic in the FoldaRap forum:
[
forums.reprap.org]
----------------
So the build is finished and the electronics now work and the printer moves!
However I am having trouble getting printer to print properly. Straight lines are.. Passable..
Circles however.. are very poor. I have attached a picture of a printed 20mm calibration cube and then a circular z-axis limiter I have tried printing which is simply not circular.
I have ensured the Z-axis extrusions are parallel and the steps are set to the point where the 20mm cube is 19.98mm on one side and 20.08mm on the other (which I am happy with) but circles just fail miserably.
I would love some help with this..
-----------------
Attachments:
open |
download -
RepRap_Forum_Calibration.jpg
(90.6 KB)