first print - please advice
Posted by polkary
|
first print - please advice September 10, 2014 03:45PM |
Hi,
I've finally printed the first cube (my setup: kossel mini printed with PLA).
The cube is only OK no perfect.
one can see the attached photo..
How can I fix those jumps\holes in my next print?
I've finally printed the first cube (my setup: kossel mini printed with PLA).
The cube is only OK no perfect.
one can see the attached photo..
How can I fix those jumps\holes in my next print?
Sorry, only registered users may post in this forum.