Welcome! Log In Create A New Profile

Ramps 1.4

Posted by tobig11

tobig11

Ramps 1.4
March 13, 2015 10:47AM

Registered: 11 years ago
Posts: 78

I'm using the Mega 2560 R3 control board with the Ramps 1.4. If I just change the ramps 1.4 board and use the same Mega board, do I have to reinstall the firmware again or is everthing on the mega 2560 board.
Thank you, Ed

Reply Quote

AndrewBCN

Re: Ramps 1.4
March 13, 2015 10:51AM

Registered: 11 years ago
Posts: 977

No, you don't have to reinstall the firmware if you change the ramps 1.4 but keep the mega 2560. The firmware is actually written to the flash memory in the MCU (the big chip on the Mega 2560 printed circuit board).

Reply Quote

jbernardis

Re: Ramps 1.4
March 13, 2015 11:59PM

Registered: 13 years ago
Posts: 1,320

You WILL need to make sure the new RAMPS board has the same jumper settings as the old board. Specifically the microstepping jumpers beneath the stepper drivers have to be in the same configuration.

Reply Quote

tobig11

Re: Ramps 1.4
March 14, 2015 05:33AM

Registered: 11 years ago
Posts: 78

The reason I'm asking is that my heatbed will not get hot and I was told that the mosfet might be bad. So if I have to take the board apart, I might as well just change the ramps. the bed starts to get hot, the red led goes on but not for long. That's as far as it goes.
Ed

Reply Quote

tobig11

Re: Ramps 1.4
May 24, 2015 03:35PM

Registered: 11 years ago
Posts: 78

Changed the Ramps board this morning, Headbed now works. From what I can tell it looks like one of the leads on the mofet is broken.

Thank you