Maxtemp error April 30, 2015 04:22AM |
Registered: 10 years ago Posts: 197 |
Re: Maxtemp error April 30, 2015 04:41AM |
Registered: 9 years ago Posts: 1,159 |
Quote
foul_owl
HI folks,
I get a maxtemp error when I hit 300C, yet my firmware is limited at 350C. I have an e3dv6 so yes it can handle high temps for special kinds of filament. Marlin firmware.
Thanks!
Re: Maxtemp error May 07, 2015 07:19PM |
Registered: 10 years ago Posts: 197 |
Re: Maxtemp error May 09, 2015 03:30AM |
Registered: 8 years ago Posts: 5,232 |
Like dougal already said: the sensor can´t show temps above 300°C. Your hotend may be much hotter, but the ramps doesn`t noticeQuote
foul_owl
I think there might be an issue with the thermistor setting in the firmware then, since I am getting delamination even at 295C.
I set the thermistor to type to "5" in the marlin firmware as described in the documentation.
Any thoughts?
Thanks!
Re: Maxtemp error May 12, 2015 06:29PM |
Registered: 11 years ago Posts: 210 |