Cannot figure out how to LOAD and UNLOAD Filament.....NEWBangry smiley
June 11, 2015 06:56PM
I just got done building this and have ONE issue left...........LOADING and UNLOADING filament.........

I am a total newb to 3d printing. The manufacturer told me to "Press extrude or reverse to change the filament......"

Nowhere in the LCD menus can I find this........am I really that stupid or what ?

This is what it was listed as on Ebay - "Reprap Delta Kossel 2020"

Thanks for any help.

Warren
Attachments:
open | download - 3444fb650172419d8c6fd7a55_thumb.jpg (29.4 KB)
Re: Cannot figure out how to LOAD and UNLOAD Filament.....NEWBangry smiley
June 11, 2015 07:32PM
What are you controlling it with? Software like Pronterface clearly has these functions . . .

- Tim
Re: Cannot figure out how to LOAD and UNLOAD Filament.....NEWBangry smiley
June 11, 2015 09:24PM
Thanks......

like I said, NEWB...........will give Ponterface a shot.
Re: Cannot figure out how to LOAD and UNLOAD Filament.....NEWBangry smiley
June 11, 2015 10:44PM
I like repetier host, try that if you don't like ponterface. Or if you have a Raspberry Pi around, install OctoPi and run OctoPrint over your home network like I do grinning smiley

Edited 1 time(s). Last edit at 06/11/2015 10:46PM by widespreaddeadhead.
Re: Cannot figure out how to LOAD and UNLOAD Filament.....NEWBangry smiley
June 12, 2015 03:06AM
It's on the LCD menu under; Prepare/ Move axis/ Move 1mm/ extruder
-a
Sorry, only registered users may post in this forum.

Click here to login