G'day all,
Yesterday my extruder has stopped working\feeding. I fiddled around and a couple of restarts and it started working again, but now it seems dead for good.
If tried a number of restarts and no good. I've set the parameter for min extruder temp to 10 degress for testing. If I take the stepper cable and swap it over with the Y-axis driver port I'm able to move the stepper motor (with repetier). But not when I plug it into the extr. driver port. I have also swapped out the pololu chip with no success.
any ideas out there on what else I can try?
than
F