other reasons for endstop being ignored?

Hi,

I had to transport my delta recently and now that im home again one of my axis ignores its endstop and smashes into it. i didnt change anything in the configuration and i continuity tested all endstops with a multimeter, m119 triggers correctly and two dofferent firmwares show the same behaviour on the same endstop.
are there any other known interferences? I never had problems with the endstops so knowledge of endstop errors is limited

Our endstopps are all beeing ignored and we have other problems with our prusia i3 Hephestos printer.

What firmware are you using?
Can you show us your configuration.h file? There should be a setting for endstop direction in there which may be set wrong, at least that was the problem when I encountered it.

Edited 1 time(s). Last edit at 10/19/2015 11:32AM by djtrance2.

Human error, i only checked the endstop plug and not the motor plugs somehow the got mixed up.

@Zack what does m119 say?