Welcome! Log In Create A New Profile

Error Message Pronterface

soccerox817

Error Message Pronterface
December 19, 2015 12:57PM

Registered: 8 years ago
Posts: 19

I keep getting this error:
Error:0
[ERROR] Error:0

along with min temp reached. I know that normally this means that the temperature sensor is broken, but I am fairly certain it is not broken because it was working just fine the other day. Could this be a problem with Pronterface?

Reply Quote

Dust

Re: Error Message Pronterface
December 21, 2015 12:55AM

Admin
Registered: 13 years ago
Posts: 7,000

Pronterface just passes messages from the controller... its the controller at fault.

Pull the thermistor plug off of your board and read the resistance of the cables and thermistor, most are are about 100k at 25c.

Reply Quote

soccerox817

Re: Error Message Pronterface
December 21, 2015 09:53AM

Registered: 8 years ago
Posts: 19

I tried to take the temperature sensor off, but it broke when doing so, so I think it was the sensor. For some reason it was stuck in the hole for it. I'm hoping that's all the problem is and when the new sensors arrive tomorrow I'll be up and running again.