Re: E3D Lite January 18, 2016 10:39AM |
Registered: 8 years ago Posts: 200 |
Re: E3D Lite January 18, 2016 11:33AM |
Registered: 9 years ago Posts: 1,159 |
Quote
Giantkiller
Are you getting Bowden tube feed or Wade direct feed. If Bowden, where did you get your single or dual head mount. I am looking to go dual myself as my Replikeo came that way but I have to replace the lousy extrusion assemblies.
Re: E3D Lite January 18, 2016 11:52AM |
Registered: 8 years ago Posts: 200 |
Re: E3D Lite January 18, 2016 12:48PM |
Registered: 9 years ago Posts: 1,159 |
Quote
Giantkiller
I am looking to make one that allows the two heads to moving vertically independently. This save having to level the heads at the nozzle end.
But right now I need a single end head mount.
Re: E3D Lite January 18, 2016 01:03PM |
Registered: 8 years ago Posts: 200 |
Re: E3D Lite January 18, 2016 01:19PM |
Registered: 9 years ago Posts: 1,159 |
Quote
Giantkiller
Thanks! Snabotutely fenominal!
I am going this route because I have not been able to print any thingies, only test prints which aren't good yet.
I'll just upload to Tinkercad and order a print! Fantastico! The price will probably kill me tho. Let's see.
I will report back here the status.
Re: E3D Lite January 18, 2016 04:44PM |
Registered: 9 years ago Posts: 182 |
Re: E3D Lite January 18, 2016 05:30PM |
Registered: 8 years ago Posts: 200 |