I'm at the config stage of my build.
Here is my setup
p3steel
Face me the endstops are placed as followed:
X = right side
Z = Lower left
Y = Rear
In Pronterface
when I press Y-home the bed moves to the rear, when it hits the endstop the bed taps the endstop a couple of times and stops <<< Is this the expected behavior?
when I press Z-Home the axis lowers to the endstop but when it hits the endstop - It continues to try and lower. <<< Why won't the endstop trigger a stop?
Have not done anything with X yet.
Thanks
Steve