how do start print in the center ? made video what printer does in cura basic settings

Forum List Message List New Topic

tenij000

how do start print in the center ? made video what printer does in cura basic settings
May 04, 2016 02:26PM

Registered: 9 years ago
Posts: 21

[www.youtube.com] this is what happens always starts in top corner right hand site

using marlin and ramps 1.4 board

Reply Quote

ggherbaz

Re: how do start print in the center ? made video what printer does in cura basic settings
May 04, 2016 05:24PM

Registered: 12 years ago
Posts: 1,401

set the center of your printer in the slicer. where to do it depends on the slicer use.

Reply Quote

stephenrc

Re: how do start print in the center ? made video what printer does in cura basic settings
May 04, 2016 05:33PM

Registered: 14 years ago
Posts: 548

Make sure you didn't check 'Machine center 0,0' and you have set the correct bed size & shape in Machine Settings.

Reply Quote

tenij000

Re: how do start print in the center ? made video what printer does in cura basic settings
May 05, 2016 05:36PM

Registered: 9 years ago
Posts: 21

i made the changes in correct bed size & shape in Machine Settings

now thing is how figure out the off set of the probe what is left and what is right on the build plate