Hi , i made my first 3d printer. I followed this guide for the most part: [
www.instructables.com] i set feedrate and correct steps per mm . I have sliced 1cm cube and started printing(i have created new settings for my printer) .Printer homed like a charm but then it stopped moving ,only z-axis and extruder was moving. I have found out that ramps tries to make that little motors go very fast .Manual control works without problems and in the settings of slic3r everything was set to 10mm/s and in the Repetier Firmware #define EEPROM_MODE is set to 0 .Help please.
Here is youtube video [
www.youtube.com]
all files [
drive.google.com]
Edited 4 time(s). Last edit at 06/05/2017 02:05PM by pipiso.