I found this one day [
ntrs.nasa.gov]
so long story short i now have a water cooled gutted wanhao I3 plus, powered by a prusa einsy board running marlin.
ive used the marlin bugfix branch and have edited all of my things i need to for my 500c thermistor and the tmc drivers. it verifys and uploads nicely. but i have two problems so far.
1. the bed temp sensor is the same it always had, a regular 100k thermistor, right now at room temp it is reading 60c. and the hot end reads 63-65c no matter what temp its at. it seems there is an auto temp setting or something that is turning on my hotend when i connect to my computer. im not sure how to turn that off but why are they doing this? am i missing something? the bed temp should atleast be working.
2. i have dowloaded the rambo and tmc librarie and edited evrything in config adv.h but still no movement. at all. do i still need to declare the spi pins in the bugfix version?
link to firmware - [
www.dropbox.com]
bottom - [
www.dropbox.com]
front - [
www.dropbox.com]
Edited 1 time(s). Last edit at 07/08/2018 06:31PM by deltajegga.