Hey again, my printer has a new issue. I was doing a print, and as it was laying down the raft, i left to eat some food. When i came back, the bed motor had stopped moving and it was just leaving big piles of filament on the bed. I tried to do some digging, and i never found a solution to this issue. When i try to home, it comes up with and error that says "Homing failed printer halted please reset. My all of my other axis work fine except for the bed motor. it makes a weird humming sound instead of moving. I tried to reflash the firmware to it many times but that never worked. Would appreciate some expert knowledge, thanks in advance.