Welcome! Log In Create A New Profile


ANTCLABS failing BLTouch units...

Posted by Bartje64 
ANTCLABS failing BLTouch units...
December 15, 2019 01:09PM
Just some info...

For those of you that are using the BLTouch, be prepared to receive "0" response from the manufacturer ANTCLABS.
I've been using these on my printers.....last one failed after 7-8 months of use. At ~$40 a crack...that gets expensive.
Have written several times to them....no response..

Time for an alternative....
Re: ANTCLABS failing BLTouch units...
December 19, 2019 06:46AM
i also had a problem that I solved by replacing the steel grubscrew with a ferrite one. Seems that the steel cannot change magnetic flux quick enough so it does not deploy/stow reliably
Sorry, only registered users may post in this forum.

Click here to login