ANTCLABS failing BLTouch units...

Just some info...

For those of you that are using the BLTouch, be prepared to receive "0" response from the manufacturer ANTCLABS.
I've been using these on my printers.....last one failed after 7-8 months of use. At ~$40 a crack...that gets expensive.
Have written several times to them....no response..

Time for an alternative....

i also had a problem that I solved by replacing the steel grubscrew with a ferrite one. Seems that the steel cannot change magnetic flux quick enough so it does not deploy/stow reliably
Cheers
Les