Axis don't move with Marlin, RAMPSTestCode moves them all June 07, 2020 12:03PM |
Registered: 3 years ago Posts: 4 |
SENDING:M119 Reporting endstop status x_min: open y_min: open z_min: openM503 returns following:
SENDING:M503 echo: G21 ; (mm) echo:Filament settings: Disabled echo: M200 D3.00 echo: M200 D0 echoteps per unit: echo: M92 X800.00 Y80.00 Z4000.00 E500.00 echo:Maximum feedrates (units/s): echo: M203 X300.00 Y300.00 Z5.00 E25.00 echo:Maximum Acceleration (units/s2): echo: M201 X3000 Y3000 Z100 E10000 echo:Acceleration (units/s2): P R T echo: M204 P3000.00 R3000.00 T3000.00 echo:Advanced: Q S T X Y Z E echo: M205 Q20000 S0.00 T0.00 X10.00 Y10.00 Z0.30 E5.00 echo:Home offset: echo: M206 X0.00 Y0.00 Z0.00 echoID settings: echo: M301 P22.20 I1.08 D114.00
Re: Axis don't move with Marlin, RAMPSTestCode moves them all June 08, 2020 08:54AM |
Registered: 6 years ago Posts: 1,863 |
echo: M92 X800.00 Y80.00 Z4000.00 E500.00
Re: Axis don't move with Marlin, RAMPSTestCode moves them all June 08, 2020 11:55AM |
Registered: 3 years ago Posts: 4 |
Re: Axis don't move with Marlin, RAMPSTestCode moves them all June 08, 2020 08:35PM |
Registered: 6 years ago Posts: 1,863 |
Re: Axis don't move with Marlin, RAMPSTestCode moves them all June 09, 2020 05:29AM |
Registered: 3 years ago Posts: 4 |
Re: Axis don't move with Marlin, RAMPSTestCode moves them all June 09, 2020 05:45AM |
Admin Registered: 13 years ago Posts: 7,000 |
Re: Axis don't move with Marlin, RAMPSTestCode moves them all June 10, 2020 01:49AM |
Registered: 3 years ago Posts: 4 |
Re: Axis don't move with Marlin, RAMPSTestCode moves them all June 10, 2020 03:43PM |
Registered: 6 years ago Posts: 1,863 |