Hi, I am using a PNP - NO inductive probe (LJ12A3-4-Z/BY 4mm 6-36V) in my Hypercube build. Previously I had a BTT SKR 1.4, but had to switch to a BTT SKR MINI v1.1. The problem is it worked fine on the previous motherboard, but I had to enable pulldownresistor in Marlin. However, my current board doesn't have such option (compiler spits out an error) and the probe stays in one logic state regardless of whether inverting option (in Marlin) is on or off and whether the led of the probe is lit or not. Is there a way to solve this or do I have to get a different sensor/board?