Hi there,
Just got my "Mk2b" heatbed and it has some tape residual and something that looks like ink "ghosting" from screen printing.
What would i use to clean it without damaging the surface coating? Alcohol? Acetone? Turpentine?
Also,
I saw a teeny tiny bit of coating chipping off from the heating "wire" and i have to ask if these things suffer from "hot spots" ??
Will that teeny tiny bit of exposed "wire" heat too much and eventually burn and fail?
Edited 1 time(s). Last edit at 03/14/2016 08:52AM by Veesta.
