Here is the link to a video of my Y Axis in action and where you can see my setup: [
www.youtube.com]
Hi RepRap,
Can you please help me figure this out, I bought all the electronic components from ebay. All the electronic components except for the the wires came from China.
My Extruder motor seems to be working fine.
I tried swapping the A4998 from the extruder to the problematic Y axis but that did not make a difference.
When I measured the amp draw during while the Y motor was moving I only saw about .3 amps.
All wires have continuity
Edited 1 time(s). Last edit at 07/03/2016 11:59AM by printerguykw.