Currently have a Reprapguru Prusa i3 mk2.
I just upgraded the main board to the new Re-Arm smoothie board.
I had previously done a rewire of the heated bed to put a 12v relay in as I melted the mosfet connector on my first RAMPs board, and I've found the wiring provided with the old board to be extremely subbar.
Now when I start the heater for my bed, I can hear the relay clicking over and over and over. I didn't like the sound so turned off the heater.
Any ideas if this can be solved firmware config-wise? Attached my current smoothie firmware config.