SO after talks with members of this forum, and a local guy I found on the internet. I made some adjustments to the steps/mm of the extruder motor to stop the stuttering I was having. this is the first and second prints on a CTC I3 Pro B. (Prusa I3 Clone). I used the only filament I have the stuff they sent me. Bed temp 70 C, and extruder temp 220C. first print took 22 min, second print took 6h39m. so far I am very impressed with outcome. Oh, I am using a Slicer called Mattercontrol, its an open source program from Matter Hackers out of Laguna Hills CA. found this to have a lot more control over the printer for troubleshooting than Cura. thanks again to any one who provided advice, and help me. I will post more prints as I go.