Creality CR-10 and Anti Backlash nuts.
Posted by Deneteus
|
Creality CR-10 and Anti Backlash nuts. August 21, 2018 04:49PM |
Would the Creality CR-10S design benefit from having Anti-Backlash nuts? I noticed that on some of the other I3 designs people use them and I figured this is the best place to ask.
|
Re: Creality CR-10 and Anti Backlash nuts. November 12, 2018 05:44AM |
It used to be common to use two nuts and a coil spring against backslash.
Today I don't do that anymore, because it doesn't make sense, the x-unit has enough weight.
It could rather favour z-wobble.
Konstruktionen: [www.thingiverse.com]
Videos: [www.youtube.com]
Mein Club: [hackerspace-ffm.de]
Drucker:
Wersybot - seit 2012
JGAurora A5
CR10-V2
Today I don't do that anymore, because it doesn't make sense, the x-unit has enough weight.
It could rather favour z-wobble.
Konstruktionen: [www.thingiverse.com]
Videos: [www.youtube.com]
Mein Club: [hackerspace-ffm.de]
Drucker:
Wersybot - seit 2012
JGAurora A5
CR10-V2
Sorry, only registered users may post in this forum.