Problem with x-axis motor June 17, 2015 07:46PM |
Registered: 8 years ago Posts: 2 |
Re: Problem with x-axis motor June 17, 2015 09:12PM |
Registered: 9 years ago Posts: 476 |
Quote
JackKahler
I am very new to the 3-d printing game and just finished building my first Prusa i3. It was no easy feat as the instructions rarely lined up. My problem is that when I go to print it runs through all of the axis's but when it gets to x-axis the motor doesn't stop. It just continues to pull until I shut it off. Any help would be greatly appreciated!!
Re: Problem with x-axis motor June 17, 2015 11:07PM |
Registered: 8 years ago Posts: 2 |
Re: Problem with x-axis motor June 18, 2015 12:04AM |
Registered: 9 years ago Posts: 476 |
Quote
JackKahler
First off, I have no idea what any of the settings you asked for are. I don't even know what a marlin has to do with 3-d printing.
Secondly, issue resolved!!!! I was just an idiot and connected the motors to the wrong input. I am so used to Y being up that I put it there instead of Z.
sarf2k4 thank you very much for helping. I was worried I had nowhere to go.
Re: Problem with x-axis motor June 18, 2015 05:11AM |
Registered: 8 years ago Posts: 5,232 |