You know the work place for i3 is 20x20x20 cm. I was wondering, if i bought a kit, then resized the mill and other needed parts so i could have a 50x50x50 cm work place. Would that be possible and would it work? I dont really know much about Arduino so would it be possible to configure it to that size? If so could you explain how? Thank you for your answers.

Check this: Prusa Titan

It's near 40x40cm I think.

---

Prusa i3, Ramps 1.4. Catnozzle 0.4mm
SketchUp - Enveloping Globoid Worm Gear - Part One - 3D Printed: [youtu.be]
DesignSpark Mechanical & more precise screw thread: [youtu.be]
Nicer Screw Thread In SketchUp ( Bolts,Nuts): [youtu.be]
How To Model A Heart Shape In SketchUp: [youtu.be]
How To Draw 3D Printable Snap Fit Ball Joint In SketchUp: [youtu.be]

Is there a place I can buy it tho? Because i checked this before and couldn't find it.