Welcome! Log In Create A New Profile

Advanced

Bad surface finish

Posted by tmccar 
Forum List Message List New Topic
tmccar
Bad surface finish
December 28, 2015 03:30AM
What might be causing these bulges on the side of my part (endstop holder), as shown in the picture?



Edited 1 time(s). Last edit at 12/28/2015 03:32AM by tmccar.
Reply Quote
AudaciousTuddle
Re: Bad surface finish
January 03, 2016 12:14PM
Have you calibrated your extruder steps/mm? It looks like you are over extruding. You should also verify that your nozzle is the same size as you have set in you slicer.
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login