Welcome! Log In Create A New Profile


(euroway reprap prusa i3) extruder issues

Posted by adexin 
(euroway reprap prusa i3) extruder issues
January 24, 2016 08:12PM
euroway reprap prusa i3 print head extruder motor wont grab/pull the filament through while trying to load or print

all other stuff work fine(heating, xyz servos, connecting via computer)

it seamed to toggle locked and free the same rate it would use to pull the filament through,pluging into the "X" axis port alows it to move as expected to. showing it may have some thing to do with the board or the chip, id try reinstalling the firmware but i dont wanna brick it

anyone know what i should do next? im lost...i was so close too....
Sorry, only registered users may post in this forum.

Click here to login