Just as the title says. I recently put together a Folger Tech Prusa I3, and the prints keep getting tipped over before it finishes.
The only thing I have tried printing is a chess piece. I have tried to find a solution on my own with no success. Any help would be greatly appreciated.

What material and print settings? What surface are you printing on? Are

---

Newbie with Folgertech 2020 i3.

looks like you are over-extruding,
[www.youtube.com]

increase the brim width in your slicing program at least 1 mm or try 2 as it helps

I am using ABS, printing on glass and using Slic3r.
I will try increasing the brim width, granted I can find that setting.

Are you putting anything on the glass? I can't get anything to stick on the bare glass.

---

Newbie with Folgertech 2020 i3.

I have been doing printing with abs and pla and have only printed onto glass, sometimes I may use support brim or raft though....
For abs I have my bed at 100c and for pla 75c

---

Folger Tech 2020 i3 Wiki

Custom google search for the Folger Tech 2020 i3 forum topic by Animoose