Hi, I would appreciate the help.

I am looking for the STL files for the Top & Bottom Mounts of the Z Axis. The one's I am looking for make the Z axis stick out further from the frame.
The normal one's are inline with the frame. These allow your X Carriage to move further out on each side of the X axis.

Thanks

I designed some replacements for either 8mm or 10mm smooth rods. I made the center piece so that the extruder misses the end mounts. There is an X belt adjuster also. Hope these help.

[www.thingiverse.com]

If all else fails read instructions. Sorry, Z Axis is not X Axis. Sorry to waste your time.