Welcome! Log In Create A New Profile

Advanced

HICTOP Prusa I3 now working great : my configuraton.h file

Posted by GeorgeL16 
Forum List Message List New Topic
Roberts_Clif
Re: HICTOP Prusa I3 now working great : my configuraton.h file
April 07, 2019 12:48PM
I have several Marlin versions configured and uploaded to a google Drive.

These were configured for My 3DP11 / 3DP12 Hictop 3D Printers with a TL-W3MC2 proximity sensor and a home made (Filament run-out sensor using the X-Max End-Stop).
I have Notes made where I changed Marlin from a SN04 to a TL-W3MC2 proximity sensor and back for the downloads.

Files changed
Configuration.h
Configuration_adv.h
Pins_RAMPS.h

Marlin 1.1.5, Marlin 1.1.7 Marlin 1.1.9BF and Marlin 2.0.x More versions not posted.

If you have any problems Post for help.

Computer Programmer / Electronics Technician
Reply Quote
Roberts_Clif
Re: HICTOP Prusa I3 now working great : my configuraton.h file
April 07, 2019 12:51PM
Now a Post for myself.

I have multiple controller from Hictop MPX.3 / Base V1.3 and MPK V1.
I do not have a complete board Connector Pin-out. I and trying to setup the second extruder with no luck.
I am asking everyone if you have connected a 2nd extruder to one of theses controllers.
Please supply me the information for connecting the 2nd extruder.

Thank You

Edited 1 time(s). Last edit at 04/09/2019 09:43AM by Roberts_Clif.

Computer Programmer / Electronics Technician
Reply Quote
Page 2 of 2    Pages: Previous12
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login